The repair kit 513EHA-1707018, installed on the valve block 513EHA-1707010 of the robotic gearbox of the Chery Beat or Chery Kimo car, includes: two cuffs on the clutch actuator piston 513EHA-1707018, the inner tube of the actuator housing, the housing seal qr512e-1707025 and the clutch position sensor EHA 513 -1707015. A simplified clutch drive repair scheme is given at the end of the repair kit description.
Breakage of the Chery Beat or Chery Kimo automatic transmission clutch cylinder may be accompanied by the following symptoms:
1. When the "sun" check on the gearbox lights up on the instrument panel and the corresponding errors P0805 or P2905.
2. It is impossible to engage any gear (more often when the cable is broken, see the repair kit with the cable), switching is possible if you turn off the car, wait and start it again, and it can also automatically switch to neutral gear while driving.
3. The robot automatic box goes into emergency mode, which allows you to engage only the first, second and reverse gears.
The easiest way to remove and install the clutch actuator of the robotic gearbox is through the bottom. To do this, you need to disconnect: 1. The high-pressure tube from the clutch cylinder housing, 2. Unfasten the connector of the clutch position sensor on the cylinder and the plastic bushing of the cable from the foot of the manual transmission 5. Three bolts of the clutch actuator bracket.